Prestige Platinum APS 400 User Manual

Page 1
SELECTABLE FEATURES
Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code. Be
certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
Wire Loop Selectable Features :
Wire Color Closed Loop Cut Loop
Gray Loop Custom Code Manual Override Valet Switch Manual Override
Green Loop Voltage Sense Hardwire
Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin switch in order
to begin the passive arming sequence.
RF Programmable Features :
Feature Selection 1 Chirp 2 Chirps Default
First 1 Second Door Locks 3.5 Second Door Locks 1 Second
Second Auto Lock On Auto Lock Off Auto Lock Off
Third Auto Unlock On Auto Unlock Off Auto Unlock Off
Fourth No Function No Function —————————-
Fifth Passive Door Locks Active Door Locks Passive Locks
Sixth Passive Arming Active Arming Active Arming
To program these selectable features;
Action System Response
Turn ignition on No response
Flip valet switch on then off 3 times 1 Chirp - LED 1 flash
Within 3 seconds, turn ignition Off Short chirp, then long chirp
First Then On 1 chirp = 1 second door locks
Press transmitter button 1 to change 2 chirps = 3.5 second door locks
or
Second Flip valet switch on then off 2 chirps = auto locks off
Press tranmitter button 1 to change 1 chirp = auto locks on
or
Third Flip valet switch on then off 2 chirps = auto unlock off
Press transmitter button 1 to change 1 chirp = auto unlock on
or
Fourth Flip valet switch on then off 1 chirp = No Function
Press transmitter button 1 to change 2 chirps = No Function
or
Fifth Flip valet switch on then off 1 chirp = passive locks
Press transmitter button 1 to change 2 chirps = active locks
or
Sixth Flip valet switch on then off 1 chirp = passive arming
Press transmitter button 1 to change 2 chirps = active arming
or
Flip valet switch on then off Exit program mode
or
Turn ignition key off Exit program mode
Note : Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the
programming will be terminated.
Model APS 400
Installation Manual

Prestige Platinum APS 400 Specifications

General

Number of Buttons on Remotes	4
Remote Start	Yes
Door Trigger	Yes
Starter Kill	Yes
Keyless Entry	Yes
Panic Mode	Yes
Valet Mode	Yes
Battery Backup	No
Shock Sensor	Yes

Summary

SELECTABLE FEATURES

Wire Loop Selectable Features

Details selectable features based on wire loop connections like color, voltage, or custom code.

RF Programmable Features

Outlines features programmable via RF transmitter, including chirps and door lock timing.

INSTALLATION OF MAJOR COMPONENTS

Core Component Installation

Guides installation for Control Module, Siren, Pin Switch, LED, Valet Switch, and Shock Sensor.

WIRING THE SYSTEM

13 Pin Edge Connector Wiring

Details connections for the main 13-pin harness, including power, ignition, and ground wires.

System Function Wiring

Wiring for voltage sense, starter disable, parking lights, ignition, and door triggers.

Advanced Wiring Functions

Covers wiring for instant triggers, second starter disable, siren, and channels 2/3 outputs.

Accessory Connectors Wiring

Instructions for connecting the Valet Switch and other accessory connectors.

Interface and Output Wiring

Wiring for LED, Shock Sensor, and various Door Lock Output configurations.

COMPLETING THE INSTALLATION