Presto precise User Manual

26
Code Cause Remedy
E10
Can appear only
in JAR WARMING
phase of Pressure and
Boiling Water Canning
Canner has developed pressure
during the JAR WARMING
phase because the regulator
was put on with its lever in the
CAN position.
• Unplug canner.
• Turn regulator lever to VENT and allow canner to release pressure.
• Remove regulator.
• Unlock and remove cover.
• Cool canner for 15 minutes.
• Add water, as necessary.
• Lock on cover.
• Plug in canner and restart program.
E20
Only in Pressure
Canning
Canner has developed pressure
during the VENTING phase
because the regulator was put
on with its lever in the CAN
position.
• See remedy for E10 above.
E21
Only in Pressure
Canning
The regulator was not installed
after the completion of the
VENTING phase.
• Unplug canner.
• Unlock and remove cover.
• Cool canner for 15 minutes.
• Add water, as necessary.
• Lock on cover.
• Plug in canner and restart program.
E30
Only in Boiling Water
Canning
Canner has developed pressure
because the regulator was put
on with its lever in the CAN
position.
• Unplug canner.
• Turn regulator lever to VENT and allow canner to release pressure.
• Remove regulator.
• Unlock and remove cover.
• Cool canner for 15 minutes.
• Add water, as necessary.
• Lock on cover.
• Plug in canner and restart program.
E50
Only in Pressure
Canning
Canner has sensed a release
of pressure during CANNING
phase as a result of:
• Removing the regulator.
• Turning the regulator lever to
VENT position.
• Sealing ring leaking because
it is damaged or needs to be
replaced.
• Unplug canner.
• Allow canner to release pressure until air vent/cover lock drops.
• Remove regulator, if still present on cover.
• Unlock and remove cover.
Canning process is not complete. To be sure your food is safe, it must
be reprocessed for the full amount of time (see page 25 for additional
information).
NOTE: If release of pressure was due to sealing ring, replacement
is necessary before using canner again. Please refer to page 30 for
ordering replacement parts.
E60
Only in Pressure
Canning
Canner has sensed a premature
release of pressure during
COOLING phase as a result of:
• Removing the regulator.
• Turning the regulator lever to
VENT position.
• Sealing ring leaking because
it is damaged or needs to be
replaced.
• See remedy for E50 above.

Presto precise Specifications

General

Capacity	6 quarts
Material	Stainless steel
Control Type	Digital
Wattage	1000 watts
Keep Warm Function	Yes
Delay Timer	Yes
Safety Features	Pressure release valve, lid lock
Cooking Programs	Rice