TECHNICAL INFORMATION
5 - 24
Vehicle Identification Number (V.I.N.)
The vehicle identification number is stamped on
a plate located on dashboard louver (entrance
door side), so that it is visible from the outside
through the windshield. It is extremely important
to give the correct vehicle identification number
when ordering replacements parts. Use of
these numbers will prevent delay and errors in
obtaining the correct material.
18041
Coach Final Record
This is a complete and detailed record of all data
pertaining to the assembly of the vehicle. This
information sheet is included in the technical
publication box delivered with the new vehicle
and should be kept in vehicle where it will be
readily available for reference.
Safety Attestation
All the components on this vehicle meet the gov-
ernment requirements:
- Material and parts conform to ASTM and/or
SAE standards in effect at time of manufac-
turing.
- Welding is in accordance with Canadian and
US standards.
- All factory-installed interior materials meet
F.M.V.S.S. 302 on fire resistance.
- Certified according to Provincial, State and
Federal Safety standards (Can. & US)
B.M.C.S.S., F.M.V.S.S., C.M.V.S.S.
Other certification labels are affixed to the spe-
cific components on the vehicle.
DOT Certification Label
This is your assurance that your new vehicle
complies with all applicable Federal Motor Vehi-
cle Safety Standards which were in effect at the
time the vehicle was manufactured. You can
find this label affixed below L.H. Side Control
Panel in driver's compartment.
18042
EPA Engine Label
The exhaust emission certification label affixed
on the lower R.H. side corner of the rear junction
box certifies that the engine conforms to federal
and any state exhaust emission regulations. It
gives the operating conditions at which certifica-
tion was made.
01011
To Next Page
Loading...
Need help?
General
