OTHER FEATURES 5-23
PA1633 X3-45 Commuter Operator’s Manual
Priority Messages
No Priority Message will be displayed during the first 10 seconds after ignition ON.
Priority messages can be generated by the engine, transmission or UDS controllers (ACM) or binary
inputs.
Priority messages will interrupt the bottom line of the LCD in order to provide the technician with priority
information.
A priority message is removed from the display only if its source expires or if the trip button acknowledges
it. Some messages can be acknowledged. If acknowledged, it remains removed from the display and will
only reappear if the source expires and reoccurs. If the ignition is turned off and then back on and a
priority message is still active, it will display again.
If more than one priority message is active, each message will be displayed one after the other for three
seconds each.
Communication is re-established
Communication is re-established
Communication is re-established
Communication is reestablished
message clears after 30 sec
Alternator charging failure
Binary input or flag turn off
12V voltage > 12V for 30sec or
24V voltage > 24V for 30sec
12V voltage < 17V for 30sec or
24V voltage < 30V for 30sec
Check Diesel Particle Filter
Change Diesel Particle Filter
Low Secondary Air Pressure