EasyManua.ls Logo

Pride Mobility CELEBRITY X - XI. Care and Maintenance

Pride Mobility CELEBRITY X
42 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
39
Celebrity X www.pridemobility.com
XI. CARE AND MAINTENANCE
CONSOLE, CHARGER, AND REAR ELECTRONICS
n Keep these areas free of moisture.
n Allow these areas to dry thoroughly if they have been exposed to moisture before operating your scooter again.
FUSE REPLACEMENT
In the event a fuse should cease to work:
1. Remove the fuse by pulling it out of its slot.
2. Examine the fuse to be sure it is blown. See figures 23 and 23A.
3. Insert a new fuse of the same rating.
WARNING! The replacement fuse must exactly match the rating of the fuse being replaced.
Failure to use properly rated fuses may cause damage to the electrical system and may
result in personal injury.
STORING YOUR SCOOTER
If you plan on not using your scooter for an extended period of time, it is best to:
1. Fully charge its batteries prior to storage.
2. Disconnect the batteries from the scooter.
3. Store your scooter in a warm, dry environment.
4. Avoid storing your scooter where it will be exposed to temperature extremes.
WARNING! Always protect batteries from freezing temperatures and never charge a frozen
battery. This damages the battery and can cause personal injury.
For prolonged storage, you may wish to place several boards under the frame of your scooter to raise it off of the
ground. This takes the weight off the tires and reduces the possibility of flat spots developing on the areas of the
tires contacting the ground.
Figure 23. Working Fuse Figure 23A. Blown Fuse (Replace)

Other manuals for Pride Mobility CELEBRITY X

Related product manuals