11
Rally
Your Rally is a motorized electric Scooter designed to enhance your personal mobility. Your Rally is an
indoor/outdoor Scooter that was designed to travel primarily on smooth surfaces, such as footpaths, roads,
parking lots, floors, and driveways. For easy transportation or storage, you can disassemble your Rally into
seven components. See figure 5.
CONTROL CONSOLE ASSEMBLY
The control console assembly houses all of the controls you need to drive your Rally; including, the key
switch, the speed adjustment dial, the throttle control lever, the battery condition meter, the horn button,
and the light switch (optional). See figure 6.
IV. DESCRIPTION
Figure 5. Seven Rally Components
SEAT
FRONT SECTION
BASKET
BATTERIES
REAR SHROUD
REAR SECTION
WARNING! Do not expose the control console assembly to moisture. In the event that the console
does become exposed to moisture, do not attempt to operate your Rally until the control console
assembly has thoroughly dried.
Key Switch
n Fully insert the key into the key switch to power up (turn on) your Rally.
n Pull the key out to power down (turn off) your Rally.
WARNING! If the key is removed from the key switch while your Rally is in motion, the electronic
brakes engage and your Rally comes to an abrupt stop!
Speed Adjustment Dial
This control dial allows you to preselect and limit your Rallys top speed.
n The image of the tortoise represents the slowest speed setting.
n The image of the hare represents the fastest speed setting.
To Next Page
Loading...
