Pride Rally - Batteries and Charging; Safe Battery Charging Procedures

16 Rally
You have the option to use either 32 AH or 17 AH batteries for your Rally. Your Rally was preset to use 32 AH
batteries. If you decide to use 17 AH batteries, you must install the two provided battery spacer brackets.
Follow these easy steps to install the battery spacer brackets:
1. Position the spacer bracket in the battery well. See figure 8.
2. Align the holes in the spacer bracket with the holes in the battery well.
3. Install the Christmas tree clips. See figure 9.
4. Repeat steps 1-3 for the second spacer bracket.
V. BATTERIES AND CHARGING
Your Rally requires two long-lasting, 12-volt, deep-cycle batteries that are sealed and maintenance free.
They are recharged by an onboard 2,5-amp charging system designed for ease of use and convenience. See
figure 7.
n Charge your Rallys batteries prior to using it for the first time.
n Keep your batteries fully charged to keep your Rally running trouble free.
Follow these easy steps to charge your batteries safely:
1. Position your Rally close to a standard wall outlet.
2. Remove the key from the key switch.
3. Make certain that the freewheel lever is in the down (drive) position and not in the up (freewheel)
position.
4. Plug the charger power cord into the charger power cord receptacle at the rear of your Rally. See figure 7.
5. Extend the charger power cord and plug it into the wall outlet.
6. We recommend that you charge your Rallys batteries for 8 to 14 hours.
7. You can, if you wish, periodically check the battery condition meter by inserting the key in the key
switch, examining the battery condition meter, and then removing the key. See figure 6. As the batteries
charge, the battery condition meter approaches the 100% reading.
8. When the batteries are fully charged, unplug the charger power cord from the wall outlet and then from
the charger power cord receptacle at the rear of your Rally.
9. Place the charger power cord in a safe place for future use.
CHRISTMAS TREE CLIP
Figure 8. Positioning the Spacer Bracket
Figure 9. Installing the Christmas Tree Clips
SPACER
BRACKET
WARNING! Never use an extension lead to plug in your battery charger. Plug the charger directly
into a properly wired standard wall outlet.