1/5th RAMINATOR MONSTER TRUCK
Troubleshooting Guide (continued)
The servos aren’t moving in correct direction
o Check servo reverse functions on the transmitter.
The brakes are not working, but the brake servos are moving
o Adjust cable wire to ensure that the brake is pulling properly on the calipers.
o Check to make sure brake pads are not worn out.
o Check that drive line axle pins and driveshaft pins are not broken.
Reverse is not working
o Make sure you stop the truck from rolling before switching to reverse.
o Check that your idle is low. If idle is too high, The clutch may start to engage, preventing the reverse
function from working properly.
o Adjust the reverse servo cable to ensure that it is pulling enough to engage reverse properly.
o Check that transmitter switch is on
o Check that truck’s battery switch is on
o Check the wire connections. Make sure they're intact and connected properly.
o Check that your batteries are charged
o Check to make sure your transmitter and receiver are bound.
The servos aren’t responding, or the transmitter is not connecting
o If the idle is too low, turn the carburetor idle screw clockwise to raise idle. If the idle is too high turn it
counterclockwise until the desired idle is reached. Idling as low as possible is recommended without the
engine stalling. The clutch may start to engage, preventing the reverse function from working properly.
The engine doesn’t idle well
To Next Page
Loading...