Primare A10 - Using a Source; Changing the Balance

<
Using the A10 Integrated Amplifier
5
SELECTING A SOURCE
The A10 Integrated Amplifier provides a choice of six line inputs, labelled:
TUNER, TAPE, CD, AUX1, AUX2, and AUX3.
To select a source
• Press the button corresponding to the source you want to select until the
name of the source is displayed on the front panel display.
For example:
23
CD
• Alternatively, press the SEL A or SEL V buttons on the C30 Remote
Control to step between sources.
CHANGING THE VOLUME
The A10 allows you to vary the volume from 0 (silence) to 79 (maximum
volume), where each step is equivalent to 0.5dB.
To change the volume
• Rotate the volume control on the front panel, or press the VOL A or
VOL V buttons on the C30 Remote Control.
The current volume setting is shown on the front panel.
For example:
24
CD
CHANGING THE BALANCE
You can change the balance of the sound between the left and right channels
to shift the position of the stereo image.
To change the balance
• Press the MENU button on the C30 Remote Control.
The front panel display shows the current balance setting, where -6
corresponds to the leftmost position, 0 corresponds to centre, and 6
corresponds to the rightmost position.
For example:
-2
CD
• Press the VOL A and VOL V buttons on the remote control to adjust the
balance.
• Press the MENU button again to revert to the normal volume display.
Alternatively the normal display will revert automatically after four seconds.