Need help?Do you have a question about the Primare A10 and is the answer not in the manual?
General| Type | Integrated Amplifier |
|---|---|
| Signal to noise ratio | > 100 dB |
| Power Output | 50W into 8 Ohms |
| Frequency Response | 20 Hz - 20 kHz |
| Inputs | RCA, XLR |
| Outputs | Speaker terminals |
| Damping Factor | >100 |
Amplifier provides 50 Watts per channel with excellent thermal dissipation for cool operation.
Offers five inputs for flexible source connection and a tape monitor function.
Rear panel allows separate pre/power amp use, providing flexibility for system integration.
Features a classic circuit design with J-FET inputs and bipolar outputs for high performance.
Controlled via simple front panel controls or the C30 Remote Control.
Overview of front panel buttons and volume control for amplifier operation.
Explains information shown on the front panel display and its indicators.
Instructions for switching the amplifier on, off, and to standby mode.
How to select and use the different line inputs for audio sources.
Adjusting the stereo balance between left and right channels for soundstage.
Guide for making recordings using the tape output and monitoring sources.
Illustrates and labels all input/output connections on the rear panel.
How to connect loudspeakers to the amplifier's output terminals.
Describes the line-level output for connecting to other preamplifiers.
Explains using the power amplifier stage as a standalone unit via MAIN IN sockets.
Details connecting tape recorders using TAPE OUT and TAPE IN sockets.
To Next Page
