22 Advanced Configuration Settings
; 0 = DBGLVL_ZERO
; 1 = DBGLVL_TRACE
; 2 = DBGLVL_DUMP
; 3 = DBGLVL_INFORM (default if not specified)
; 4 = DBGLVL_WARNING
; 5 = DBGLVL_ERROR
; 6 = DBGLVL_FATAL
DebugThreshold = 3
; Number of passes override
;For 600x600 NumPasses can be: 1,2,3,4,6,8,12,16
; NOTE: this only works for Quality 1
Slot1NumPassesOverride=1
Slot2NumPassesOverride=1
; Carrier speed override
; CarrierSpeed can be 0-40
;Slot1CarrierSpeed=30
;Slot2CarrierSpeed=30
; Bypass the alignment required warning?
; 0 = don't bypass the warning (DEFAULT) 1= bypass the warning
; NOTES:
; 1. This only works if cartridge setting is set to Color only or Black only
; 2. USE AT YOUR OWN RISK - BYPASSING ALIGNMENT MAY NOT PROVIDE OPTI-
MUM PRINT QUALITY
; (for best print quality you should align after changing cartridges).
; 3. The warning will still show up after changing the cartridge, but you can Cancel. The
warning will not be given when printing.
BypassAlignWarning=1
; This value sets the delay before presenting the label after no activity
; Units are 0.1 seconds (e.g. value of 10 will cause a delay of 1 second before presenting the
label)
; This only applies when the printer output mode is "Present after no activity"
PresentDelay = 10
; This value sets the behavior of the horizontal scan. This scan attempts to keep the left margin
consistent
; even if the label moves horizontally.
To Next Page
Loading...
