Advanced Configuration Settings 23
; 0 = disable horizontal scan
; 1 = enable scan at the end of each print (fast but may not be as accurate - if printing is full
bleed or too close the the
; edge of the label then it may scan at the beginning of the next label).
; NOTE: when Output mode is set to Present or Cut then it will always scan at the beginning
of the first label
; 2 = enable scan at beginning of each print (slower but might be more accurate)
; 255 = no change from previously used setting
HorizontalScan=1
; Extra maintenance
; 0 = Idle Time maintenance
; 1 = Job Start (uncap) maintenance
; 2 = Threshold maintenance
; 3 = POR maintenance
; 4 = Single wipe only (no spits)
; 5 = Install maintenance
;
; You can specify that extra maintenance be done at the beginning of each print with this setting
; This can be utilized if the prints tend to be light at the beginning of the print
;
;ExtraMaintenance = 1
; Output mode override - for PX450
; 0 = do not present/cut the label
; 1 = Cut after no activity (using PresentDelay value)
; 2 = Cut every label
; 5 = No change in output mode (this is the default value)
OutputMode=5
;; Feed length of print after cutting
;; Set to 1 to enable (default ), 0 to disable
;; Doing this may help when printing labels > 3 inches and when running at faster speeds (see
below)
FeedAfterCut=1
;; TOF Sensor Type override
;; You can override the value of the TOF sensor setting in the printer with this key
;; 0 = Through Mode (e.g. Die Cut stock)
To Next Page
Loading...
