24 Advanced Configuration Settings
;; 1 = Reflective Mode (e.g. Black mark on back)
;; 2 = Continous Stock (don't use sensor)
;; 255 = Use printer setting (this is default)
TOF_Sensor = 255
; Flash frequency - for LX400
; Number of times per second to blink the LED
; (starts at beginning of RIP and stops when data starts getting sent to printer)
; Purpose: indicates that data is being ripped and printer is waiting
LEDFlashFrequency=3
; //// Feed Speed control ////
;;; Faster Speed set to 55
;;; Slower Speed set to 35 (default)
ForwardSpeed=55
PrintSpeed=55
ReverseSpeed=55
; /// POS Applications ///
; Send an "Ink Low" Print automatically when the ink is low.
; The print will be sent after every regular print - until the ink is not low anymore
; Set to 1 to enable, 0 to disable
PrintInkLowWarning=1
; //// Show Error Messages ////
; Whether or not to show error message boxes
; 0 = don't show, 1 = show (default)
SHOW_UI=0
; //// Maintenance during Idle ////
;;; CapTime = Number of seconds before the cartridge goes back home (after printing)
;;; For PX450 the Default = 30 minutes = 1800
CapTime = 1800
;;; PenIdleMaintainTime = Number of 1/2 seconds between maintenance while idle (and not in
home position)
;;; For PX450 the Default = 2 minutes = 240
PenIdleMaintainTime = 240
To Next Page
Loading...
