TX300 S3 Operating Manual 85
Troubleshooting and Tips Error Message on Screen
Power failure during the enable sequence
The enable sequence has been aborted. The PCI board was either not installed
correctly (tilted) or the PCI board is defective.
Ê Remove the board from the slot and put it back in correctly.
Ê Repeat the enable process (see section “Hot-pluggable PCI boards” on
page 100).
If the error occurs again, the PCI board is probably defective.
Ê Repeat the operation with a new PCI board.
If the error still occurs, contact our Service group.
7.13 Error Message on Screen
The meaning of the error message is explained in the manual for the BIOS Setup
and in the documentation for the relevant components and programs on the
PRIMERGY ServerBooks DVD.
To Next Page
