If the appliance is to remain unused for a extensive period, disconnect it and remove all food outside. After de-icing, clean
and dry the inside of the appliance. In order to prevent unpleasant odour, leave the cover of the refrigerator slightly open.
MEASURES TO BE TAKEN AFTER UNUSED FOR A LONG PERIOD
If, after an extensive lay-up period, the refrigerator does not produce any cooling, disconnect the appliance and turn it upside
down for a few minutes then turn it the right way up. After you have turned it over several times, reconnect it.
MAINTENANCE
Clean the appliance regularly with warm water, containing a detergent if necessary. Never use an abrasive product.
Dry the cleaned surfaces with a soft cloth. Use only clear water to clean the seal of the cover, and then coat the seal
with talcum powder. All repairs, particularly of the cooling unit or the gas burner system, must mandatorily be carried
out by a qualified technician.
TROUBLE SHOOTING
If a problem occurs, carry out the following checks:
• Is the appliance installed in a horizontal position?
• Is there sufficient ventilation?
• For 230/240V AC mains operation, check that the mains supply is correct. And is the thermostat set correctly?
• For battery operation, check the battery and the connection.
• For gas operation, is the burner ignited?
• Has the ignition safety (adjustment) knob been set to MAX?
• Is the gas cylinder valve open?
• Is there still a sufficient quantity of gas in the cylinder? The cylinder is empty if no liquid can be heard moving about when
it is shaken.
• Have two modes of energy (gas and electricity) been selected at the same time?
• Has too much food been placed inside the refrigerator all at once? Arrange the food so that the air is free to circulate
inside the refrigerator.
If, despite the above checks, you still need to contact the service department, describe the failure and state the type of
equipment and its serial number (these are marked on the label).
SERVICING
If you notice any of the following contact an authorised service agent.
• Change in the operation of the appliance
• Yellow flames or odour
• Smell unburned gas
If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or local
approved service agent.
This appliance has been designed to give you many years of use but dropping or rough handling could cause changes in the
operation of the appliance. If you feel that there is a change in the operation of the appliance, or if the appliance has been stored
and unused for a long period of time, take the opportunity of having its operation checked by an authorised service agent.
For service return to the point of purchase or contact your local Primus Service Agent by contacting
Primus Australia at the address on the back of these instructions.
Model No., Injector sizes, rates and serial number can be found on the data plate
NOTE:
This appliance must only be serviced by an authorised person.
To Next Page
Loading...
