Printek Emulation
Page 7-2
a documented control code or escape sequence, refer to the hex representation in the
provided example. This should clarify any ambiguity. The examples may also be
helpful when analyzing a hex dump (see chapter 8) printed by the printer.
Column and line numbers begin at zero, not at one. Keep this in mind when setting
tabs, margins, etc.
Printek emulation was developed to allow access to the full range of hardware
features available in the Printek FormsPro 4000. Other emulations typically support
some character pitches, but not all character pitches. They do not allow the 10
different form setups to be selected via software, or allow graphics of every possible
density to be printed. Printek emulation supports all of these features, and more, in
one place. This makes Printek emulation the most powerful emulation available in
the printer. We encourage you to take full advantage of all the unique features
available in Printek emulation. After all, these features are the reason you purchased
the FormsPro 4000. However, you should be aware that using these features may
prevent your software from being easily portable to other printers. If you do not
require the unique features available in Printek mode, it is probably wise to choose a
different emulation that is more widely supported.
The most common reason for using Printek emulation is to select a different form
setup (and thus change tractors). Many users switch to Printek emulation (using the
ESC ESC 7 sequence), load a new form (using the ESC L n sequence), and then
return to their standard emulation (using the ESC ESC n sequence). If you normally
use Epson emulation, please note that the Epson sequence ESC EM n allows Form 0,
1, or 2 to be selected without switching to Printek emulation.
To Next Page
Loading...
