Prismafood C/0 - Maintenance, Belt Adjustment, and Troubleshooting; Pre-Maintenance Safety Measures; Comprehensive Cleaning Instructions; Maintenance Schedule and Checks

18
MAINTENANCE
BEFORE PERFORMING ANY KIND OF MAINTENANCE INTERVENTION IT IS
MANDATORY TO DISCONNECT THE OVEN PLUG FROM THE POWER SUPPLY OUTLET.
CLEANING
Cleaning must be carried out at the end of each use in observance of the rules on hygiene and to protect
the functionality of the oven.
Cleaning the chamber:
De-energise the oven by turning the power switch.
Remove the conveyor belt joint guard.
Release the belt from the hook by moving it upwards.
Slide the joint itself towards the control panel releasing it from the conveyor belt drive shaft.
Raise the inlet and outlet sliding hoods into the maximum opening position.
Lift the conveyor belt on both sides and pull it out from the side of the controls.
Open the side door and, using a pair of gloves, remove the diffusers that are secured with screws.
Clean the metal surfaces with a sponge soaked in water and non-abrasive and/or corrosive detergent, then
rinse the surfaces with a sponge soaked in pure water.
External cleaning of the oven: (stainless steel surfaces, inspection glass and control panel): this
operation must be carried out with the oven cold.
THE OPERATOR IS ADVISED TO USE SUITABLE GLOVES AND CLOTHING TO AVOID
BURNS.
FOR CLEANING IT IS FORBIDDEN TO USE: WATER JETS, ABRASIVE POWDERS,
CORROSIVE SUBSTANCES OR ANYTHING ELSE THAT COULD DAMAGE THE
COMPONENTS AND COMPROMISE SAFETY IN GENERAL, AND IN PARTICULAR FROM
A HYGIENE POINT OF VIEW.
MAINTENANCE FREQUENCY
For any extraordinary maintenance, repair and/or replacement, contact an authorized operator who meets
the technical-professional requirements required by current regulations.
Maintenance, checks, inspections and cleaning
Regularity
Mechanical protection devices
Check condition, and for any deformation, loosening or removed parts.
Monthly
Control
Check mechanical part, for any breakage or deformation, tightening of screws. Check
readability and condition of words, stickers and symbols and restore if necessary.
Yearly
Machine structure
Tightening of main bolts (screws, fixing systems, etc.) of machine.
Yearly
Safety signals
Check readability and condition of safety signals.
Yearly
Electrical control panel
Check the electrical components installed inside the Electric Control Panel. Check wiring
between the Electrical Panel and machine parts.
Yearly
Electrical connection cable and plug
Check connection cable (replace it if necessary) and plug.
Yearly
General machine overhaul
Check all components, electrical equipment, corrosion, pipes,…
Every 10
years