Pro-face GP-4301TW - Chapter 3 Replacement Procedure; Overall Workflow

Chapter 3 Replacement Procedure
3.1 Work Flow
Receive screen data from
GP-2300 series. *1
Convert GP-2300 series
screen data with GP-Pro
EX’s Project Converter.
Check and modify the data
on GP-Pro EX.
Transfer the screen data to
GP-4301T/TW.
Connect GP-4301T/TW
and PLC with the PLC’s
Start connection and check
the communication.
Remove GP-2300 series.
Connect the power cord.
Check the performance
and start operation.
Installation Screen
Check the compatibility of
hardware in Chapter 2.
Check the differences of
specifications in OtasukePro!
[Compatibility of Software]
(http://www.pro-face.com/o
tasuke/qa/gp3000/replace/s
oft/conv/care/3/).
Check the connection
between GP-4301T/TW
and a PLC in the GP-Pro EX
Device/PLC Connection
Manual.
Install GP-4301T/TW.
Communication
*1: This step is required if screen data is saved only in the GP unit, not in any other device.
25/59