GP-4402WW/GP-4502WW Hardware Manual
23
The front face of the panel, installed in a solid panel, has been tested using conditions equivalent
to the standards shown in the specification.
Electrical
Radiated radio frequency
electromagnetic field
10 V/m / 80 MHz...1 GHz, 3 V/m / 1.4 MHz...2 GHz, 1 V/m /
2 GHz...3 GHz, sinus amplitude modulated 80 % / 1 kHz and
internal clock frequency
Electrical fast transient EN/IEC 61131-2 zone B
2 kV power supply and 1 kV shielded cables
High energy surges IEC 61000 - 4 - 5
0.5 kV (Differential mode on power supply)
1 kV (Common mode on power supply)
Electrostatic discharge immunity EN/IEC 61131-2
4 kV contact, 8 kV air
CAUTION
EQUIPMENT DAMAGE
Ensure that the panel is not in permanent and direct contact with oils.
Do not expose the device to direct sunlight.
Failure to follow these instructions can result in injury or equipment damage.
NOTICE
STORAGE AND OPERATION OUTSIDE OF SPECIFICATIONS
Store this product in areas where temperatures are within the product’s specifications.
Do not restrict or block this product’s ventilation slots.
Failure to follow these instructions can result in equipment damage.
NOTICE
GASKET AGING
Inspect the gasket periodically as required by your operating environment to keep the initial IP
level.
Change the gasket at least once a year, or as soon as scratches or dirt become visible.
Failure to follow these instructions can result in equipment damage.
Specification Value
1
For in-rush current, the FWHM (full-width, half maximum) value is approximately 50 s (when exceeding
25 A).
To Next Page
Loading...
