Need help?Do you have a question about the Pro-Ject Audio Systems Essential II and is the answer not in the manual?
General| Type | Belt Drive |
|---|---|
| Speed | 33, 45 RPM |
| Cartridge | Ortofon OM 5E |
| Output | RCA |
| Main bearing | Stainless steel |
| Effective arm length | 218.5 mm |
| Tracking force | 1.5 - 2.0 g |
| Power consumption | 4.5 W |
| Motor Type | DC motor |
| Stylus Type | Elliptical |
| Channel Separation | > 20 dB |
| Channel Balance | < 2 dB |
| Tonearm | 8.6" aluminum |
| Wow & flutter | < 0.1% |
| Signal to noise | > 60 dB |
| Frequency Response | 20 Hz - 20 kHz |
| Wow and Flutter | < 0.1% |
| Signal-to-Noise Ratio | > 60 dB |
Includes tonearm tube, counterweight, lift lever, and rest for playback control.
Advises on handling the unit, power supply, liquids, naked flames, and damp locations.
Detailed steps for balancing the tonearm and setting the downforce using the counterweight scale.
Explains how to hang the anti-skating weight thread in the correct groove for applied downforce.
Guides fitting cartridges with half-inch holes using provided screws.
Details connecting tonearm wires to cartridge pins for left/right channels.
Stresses the importance of correct cartridge adjustment using alignment tools or dealer assistance.
Lists possible causes like no power, no mains, or missing/slipped drive belt.
Covers issues from cartridge to amplifier connections, input selection, or amplifier/speaker problems.
Primarily addresses lack of earth connection or earth loops.
Points to incorrect input, MM/MC switch, damaged needle, or wrong speed/belt issues.
To Next Page