4
Safety
Precautions to follow when using any laser.
• Don't stare into the laser beam or view it directly with optical instruments.
• Don't disassemble the laser or attempt to service it.
• Don't use the laser until you have read the instruction manual and you are
familiar with how to operate the laser properly.
U.S. OSHA requirements for operating visible lasers.
• Only qualified, trained employees may install, adjust and operate the laser.
• Laser operators must carry proof of qualification.
• The area of a job site where a laser is being used must be posted with a
laser warning placard.
• The laser should be set up above or below eye level and never intentionally
aimed at anyone.
• Turn the laser off when it is not being used, such as during lunch hour, at
the end of the day, or during other long breaks in the work.
Note: The L1-AS is a CDRH class II laser and an IEC 60825 class 2 laser.
The L1-AS
M MAGNUM is a CDRH class IIIa laser and an IEC 60825 class 3R
laser. Both models conform to applicable EC directives regarding RFI and
EMI and to FDA performance standards 21 CFR subchapter J.
Laser
Light is emitted
from this aperture
AVOID EXPOSURE
Serial / CDRH / EC compliance
Serial No.
Manufactured by: Laser Reference, Inc.
151 Martinvale Lane • San Jose, CA 95119
This product complies with FDA
standards 21 CFR subchapter J
X 000000
Aperture warning
CDRH / IEC
warnings
CHARGE ONLY
RECHARGEABLE
BATTERIES
CAUTION
LASER LIGHT
DO NOT STARE
INTO BEAM
CLASS II LASER PRODUCT
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
635nm - 670nm
Safety label locations • AS2
To Next Page
Loading...