6
Safety and Compliance
Precautions that should be followed when using any laser.
• Don't stare into the laser beam or view it directly with optical
instruments.
• Don't disassemble the laser or attempt to service it.
• Don't use the laser until you have read the instruction manual
and you are familiar with how to operate the laser properly.
U.S. OSHA requirements for operating visible lasers.
• Only qualified and trained employees are to install, adjust and operate
the laser. (see operator card included with this manual package)
• Laser operators must carry proof of qualification.
• The area of a job site where a laser is being used must be posted with
a laser warning placard (included with this manual package).
• The laser should be set up above eye level and never intentionally
aimed at anyone.
• Turn the laser off when it is not being used, such as during lunch hour,
at the end of the day, or during other long breaks in the work.
Note: The L3 transmitter is a class IIIa (less than 2.5mW) laser under the
United States C.D.R.H. guidelines.
The L3 is a class 3R laser under the 1993 IEC 825-1 laser safety standard
(revised edition of the European Norm EN60825).
The L3 conforms to applicable EC directives regarding RFI and EMI.
The L3 complies with FDA performance standards 21 CFR subchapter J.
A warning placard is
included with each laser.
It may be attached to the
carrying case - with the
case placed in a visible
location near the laser -
for meeting job site
posting requirements.
CAUTION
LASER LIGHT - DO NOT STARE
INTO BEAM OR VIEW DIRECTLY
WITH OPTICAL INSTRUMENTS
MAXIMUM POWER < 2.5mw
AT 630-650nm
CLASS IIIa LASER PRODUCT
LASER LIGHT
DO NOT STARE INTO BEAM
OR VIEW DIRECTLY WITH
OPTICAL INSTRUMENTS
CLASS 3R LASER PRODUCT
To Next Page
Loading...