ProBoat ZELOS 48G - Post-Boating Care and Control Trim; After Boating

Owner’s Manual
Steering Trim
UsetheST. Trimknobonthetransmittertoadjustthe
steeringtrimtocentertherudder.Iftheservoarmis
notclosetoitsdesiredneutralpositionafterthebinding
processandtheruddercannotbecenteredusingtrim,
pleasetakethefollowingsteps:
1. MakesuretheST. Trimknobissetto“0”orneutral.
2. Adjustthelinkagetotheservosotherudderis
centeredwhenthesteeringisatneutral.
Throttle Trim
AdjusttheTH. Trimsothecarburetoriscompletely
closedwhenthethrottletriggerisatneutral.Ifthe
throttlecannotbeclosedusingTH. Trim,follow
thesesteps:
1. MakesureTH. Trim knobissetto“0”orneutral.
2. Useneedle-nosepliersorballlinkpliers(RVO1005)to
removeorinstallalinkonacontrolhorn.
3. Turnthelinkageclockwiseorcounterclockwiseuntil
thethrottleisclosed.
4. Attachthelinkagetothecontrolhornafter
adjustment.
NOTICE:Throttletrimchangemayaffectengine
operation.Carburetorsettingsmustbesetcorrectlyor
damagemayresult.
• Drainwaterfrominsidethehullusingtheauto
bailers.
• Wipeexhaustresiduefromtheboat.
• Rinsethedeck,hull,andmetalhardware,thendry
themwithacleantowel.Coatthemetalhardware
withwaterdisplacementfluidtohelpprevent
corrosion.
• Fullydrytheinsideandoutsideoftheboat,including
thewatercoolingsystem.Removethehatchbefore
storingyourboat.
• Applyanautomotivewaxcoatingtotheexteriorof
yourboattopreventoxidationandtoprotectagainst
damagecausedbyfuelorotherharmfulchemicals.
• Repairanydamageorweartotheboat.
• Lubricatetheflexshaft.
• Makenoteoflessonslearnedfromthetrimmingof
yourboat,includingwaterandwindconditions.
NOTICE: Whenyouarefinishedboating,neverleave
theboatindirectsunlightorinahot,enclosedarea
suchasacar.Doingsocandamagetheboat.
After Boating
13
EN