EasyManua.ls Logo

ProBoat ZELOS 48G - Radio System Binding and Control Check; Binding; Control Check

ProBoat ZELOS 48G
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Zelos™ 48-Inch Gas Catamaran
Binding
The included transmitter and receiver are bound at
the factory.Ifyouneedtorebind,followtheinstructions
below.
1. Ensurethetransmitterandvehiclearebothpowered
OFF.
2. Removetheradioboxcoverandinstallthebindplug
intheBIND/batteryportofthereceiver.Powerthe
receiverthroughanyotherport.
3. PowerONthevehicle.ThereceiverLEDwillblink
green.
4. Standapproximately8–12feet(2.4–3.7m)fromthe
vehicle.Withthesteeringwheelandthrottletrigger
inthefailsafepositions(neutral),pressandhold
thebindbuttonandpowerONthetransmitter.The
transmitter’sgreenLEDwillblinkafter3seconds,
indicatingitisinbindmode.
5. ReleasethebindbuttonwhenthegreenLEDflashes.
Continueholdingfailsafepositionsuntilthebinding
processiscomplete.
6. ThereceiverLEDwillglowsolidwhenthetransmitter
andreceiverarebound.
7. PowerOFFthevehicle,thenthetransmitter.
8. Removethebindplugandstoreitinaconvenient
place.
9. Reinstalltheradioboxcover.
Thereceiverwillkeepthebindingtothetransmitteruntil
anotherbindingisdone.
Ifyouencounterproblems,obeybindinginstructionsand
refertothetroubleshootingguideforotherinstructions.If
needed,contacttheappropriateHorizonProductSupport
ofce.
NOTICE:Donotattempttobindthetransmitterand
receiverifthereareothercompatibletransmittersinbind
modewithin400feet.Doingsomayresultinunexpected
binding.
Failsafe
Intheunlikelyeventthattheradioconnectionislost
duringuse,thereceiverwilldrivetheservostotheirpre
programmedfailsafepositions(normallynothrottleand
straightsteering).
Ifthereceiverispoweredonbeforepoweringonthe
transmitter,thereceiverwillenterthisfailsafemode.
Whenthetransmitterispoweredon,normalcontrolis
resumed.
IMPORTANT:Failsafeactivatesonlyintheevent
thatsignalislostfromthetransmitter.Failsafewill
NOTactivateintheeventthatreceiverbatterypower
decreasesbelowtherecommendedminimumsorpower
tothereceiverislost.Werecommendcheckingyour
battery(DYN4071)beforeuse.
Control Check
IMPORTANT: Performacontrolcheckatthebeginning
ofeachboatingsession,afterrepairorafterinstallationof
newbatteries.
Ensurethereceiverantennaisextendedproperlyandall
batteriesarefullycharged.
1. PowerONthetransmitterandtheboat.Do not
install the boat canopy.
2. Placetheboatsecurelyontheboatstand.
NOTICE: Donotoperatetheenginewithoutwater
coolingcirculationordamagemayresult.
3. Checksteeringandthrottleonthetransmitter.
8
EN

Related product manuals