18 of 24 | English English | 19 of 24
To attach the water hose:
Step 1: Unscrew the continuous drain cap, unplug the drain plug, and store safely.
Step 2: Insert the water hose into the water outlet. Tightly secure in place.
Step 3: Feed the other end of the water hose to a suitable drainage outlet (e.g. a drain or bucket).
Note: When the appliance is set at a warm temperature it is recommended to attach the water
hose as the water tank will ll at a faster rate than when set at a cold temperature.
CLEANING
―
WARNING: NEVER LEAVE WATER IN THE WATER TANK WHEN
THE APPLIANCE IS NOT IN USE, MICROORGANISMS CAN
GROW IN STAGNANT WATER, THE WATER TANK SHOULD BE
EMPTIED AND CLEANED REGULARLY.
CAUTION: DO NOT USE ANY ABRASIVE CLEANERS OR
SOLVENTS, AS THIS WILL DAMAGE THE APPLIANCE. DO
NOT ALLOW WATER OR OTHER LIQUIDS TO RUN INTO THE
INTERIOR OF THE APPLIANCE, AS THIS COULD CREATE A FIRE
AND/OR ELECTRICAL HAZARD.
• Do not attempt to clean the appliance in any other way
than that detailed by the manufacturer.
• Cleaning and user maintenance shall not be made by
children.
Exterior Cleaning:
• Clean the exterior surface of the appliance by wiping
it with a soft, damp cloth. Dry the appliance with a soft,
clean cloth.
• Clean the vents and openings of the appliance regularly
with a vacuum cleaner, using the brush attachment to
avoid any dust build-up.
CAUTION: DO NOT OPERATE THE APPLIANCE WITHOUT THE
FILTER. THIS WILL CAUSE IT TO CLOG UP WITH LINT AND DIRT
AND WILL REDUCE PERFORMANCE. ALWAYS INSERT THE
FILTER SECURELY.
Clean the appliance’s evaporator and condenser filter once
every two weeks.
To remove and clean the lters:
1. Grip the first filter by gripping the handle to the left of the
upper air inlet grille and gently remove.
2. Upon removing the first filter the second filter handle will
be exposed. Gently remove the second filter.
3. Use a firm brush and or vacuum cleaner to clean the
filter of any dust and particles.
4. Return both the second filter and then the first filter to the
upper air inlet grille.
To Next Page
Loading...
