Page 2 AVP RS-232 Quick Guide
Software Revision
The information contained in this document is intended to control AVPs with the latest revision of
software and hardware. This section describes the necessary hardware and software needed to
control an AVP via RS-232.
Before programming and installing the AVP, please verify that the AVP contains the following.
Software in the AVP must be v3.13. The following describes how to identify software in
an AVP.
Identifying
Downloadable
Software
Release Date:
5/16/01 Starting s/n:
4885
About Screen ID
AVP ID :05090116
The ABOUT screen in the AVP on-screen menu lists the
software version IDs. The first 6 digits in each ID
represent the software development date.
DSP ID :0374:6
Identifying
Hardware
A change was made to the way an AVP is controlled via RS-232. To ensure that the
AVP will function correctly the following parts must be installed in the AVP.
Part # 770445 New UI front panel chip
Part # 770451 New Software flashchip
The parts listed above store the downloadable software, IR and RS-232 control of the
AVP. Any AVP that contains software higher then v3.13 has these parts. The above
parts can NOT be used with software below v3.13.
Retrieving
Software
The software can be found on the Madrigal Software Website. Please refer to Technical
Service Document # MLPR81099 for information on accessing the site.
Files to Download AVPOS330.DLF AVPDS330.DLF
To Next Page
Loading...
