PROCEED Digital Surround Decoder - Control Trigger 2 Menu; Rear Ir Input Menu

52
Digital Surround Decoder can provide). If this is the case, you can use control
trigger 1
as a switch by placing it in series with an external power source such as
a “wall wart” power supply.
Warning! There are no user serviceable parts inside the PDSD. If you
need one of the internal settings changed to support your
installation, please contact your dealer.
control trigger 2 menu The control trigger 2 menu is exactly the same as that for conrtol trigger 1, except
that only control trigger 1 can be set for use as a dry contact relay with an exter-
nal power source such as a “wall wart” power supply. See control trigger 1 menu,
above.
rear ir input menu The infrared remote input jack on the rear panel of the PAV may be programmed
to respond to either local commands (e.g., duplicating the functionality of the IR
receiver in the PAV’s main display) or remote commands (e.g., from an IR re-
peater, to affect only the remote signal path). (Refer to the Remote IR and Remote
Turn-on section of your PAV manual for more information.)
The factory default setting is remote. If your installation of the PAV/PDSD pre-
vents IR commands from reaching the PAV (as when behind closed doors, for ex-
ample), and if you are using an IR repeater to pass IR commands to the system,
you may wish to set the IR input on the rear panel to local, in which case you
would also want to “hard-wire” the PAV to your IR repeater. To make this software
change, follow these steps:
1 ENTER THE CUSTOM MENU
This menu is accessed from the main menu by moving the cursor to
custom, and pressing enter to select the menu item.
2 SELECT REAR IR INPUT
Using the volume ± buttons, move the cursor to rear IR input and press
enter.
3 TOGGLE THE MENU ITEM FROM REMOTE TO LOCAL
Press either of the volume +/– keys to change the default setting of
remote to local. Press enter to save the change.
Important: Note that this change will not take effect until you back out of
the on screen menus and return to normal operation. This
delayed response allows you to continue to use the IR
receiver on the main display long enough to finish what you
are doing. It will be turned off in favor of the IR input jack
once you leave the menu system.