PROCEED Digital Surround Decoder - Proceed PAV;PDSD System Quick Start

92 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

83

Table of Contents

Default Chapter1
- Unpacking the Digital Surround Decoder1
  - Important Safety Instructions3
  - Table of Contents4
Maximizing the Value of Your Purchase7
- Send in that Warranty Card7
Unpacking and Placement8
- Placement8
- Ventilation8
  - Serial Number Label9
- Update You PAV Software9
- Register Your Purchase9
Operating Voltage & Frequency10
- Warm Up/Break-In Period10
A Word about Installation11
A Quick Start for CD12
A Quick Start for Laserdisc13
Special Design Features14
- Hardware Upgradable14
- Software Updatable14
- Multichannel14
- Audio Computer15
Front Panel16
Rear Panel18
- Ac Power Cord Polarity19
Learning Remote Control19
- Installing Batteries in the Remote Control19
Using the Menu System25
- To Enter the Menu System25
- To Exit the Menu System26
- To Select a Menu Item26
- To Change a Menu Item26
- To Save Changes26
- To "Escape" or "Cancel" Without Saving any Changes26
- Front Panel Equivalents26
The Operate Menu27
- Display Position27
- Status Preferences27
- Display Timeout28
- Display of Text28
- Display Background28
- Volume Display28
- Volume Speed29
- Volume Mute Level29
- Maximum Volume29
- Dialog Normalization29
- Auto Migration29
  - Forced/Manual Migration29
- Setup: Locked/Unlocked29
The Setup Menu31
- Set Source Buttons32
- Example: Setting up a CD Transport32
- The Custom Menu48
- The about54
- Planning Your Installation55
- System Planning Guide59
- Using PAV/PDSD61
Programming the Remote Control64
- Programming Other Components' Functions64
  - Teaching the PAV Remote Control New Commands65
Planning Your Remote Control66
- The Proceed Bank: Left66
- The Proceed Bank: Center66
- The Proceed Bank: Right66
- Bank 2: Left67
- Bank 2: Center67
- Bank 2: Right67
Your System Settings68
- Operate Menu Settings68
- CD 1 Button Defaults68
- CD 2 Button Defaults68
- Tape 1 Button Defaults69
- Tape 2 Button Defaults69
- Bal/Aux Button Defaults69
- Tuner Button Defaults69
- Vcr 1 Button Defaults70
- Vcr 2 Button Defaults70
- Laserdisc Button Defaults70
- Tv/Aux Button Defaults70
- Low Freq Cutoff Settings71
- Set Distance71
- Set Levels71
- Bass Level Manager71
- Mode Defaults: Discrete71
- Mode Defaults: Pro Logic71
- Mode Defaults: Stereo Surround71
- Mode Defaults: Mono Surround71
- Mode Defaults: Surround off72
- Mode Defaults: Mono72
- Control Trigger 172
- Control Trigger 272
- Rear Ir in72
- Ir Address72
Room Acoustics73
- Room Reverberation73
- The Boundary Effect73
- Room Modes74
Troubleshooting75
Care and Maintenance77
U.S. and Canadian Warranty78
- 90-Day Limited Warranty78
- Five Year Extended Warranty78
Obtaining Service79
Specifications80
Dimensions81
Installation Notes82
Proceed PAV/PDSD System Quick Start83