Moving to the next Object
To move to the next object simply switch the Resipod off and then on again.
Note: The Resipod will always move to the next object when you switch it on and off.
If you wish to carry on measuring in the previous object, simply delete the current
reading as described below and you will be returned to the previous object.
Deleting a reading
The last reading has been stored in Object 4 – Reading 3.
To delete this reading, press the hold button to set the display
blinking.
(If the Resipod is held in the air for this the “open line” screen
will be displayed and will blink.)
Press the “Save” button for 2 seconds to delete the reading.
Object 4 – Reading 3 has been deleted. The display shows a
small “c” to indicate the last reading has been cancelled. Subse-
quent readings can be cancelled this way, but only sequentially.
It is not possible to scroll back and delete an earlier reading.
Memory status indications
A number of special screens provide information about the status of the memory.
Object number is >19.
All 19 objects have been used. It is necessary to delete readings
before using the memory further (see above).
Reading number is >99
The current object is full. Move to the next object to store further
readings (see above).
Memory is empty.
To Next Page
Loading...
Need help?
General
