Page 17
• which type of applicator you will be using
• which substrate you will be using
• which base plate you will be using
- precision-vacuumplate
- heatable precision-vacuumplate (only versions with special isolation plate)
- heating plate (only versions with special isolation plate) or
- glass plate
The heatable precision-vacuumplate and the heating plate can be used with all
rods. If the glass plate is used (i.e. no heatable application is performed), the
following should be noted:
If using a wire-bar or profile rod, use the printing blanket side of the glass plate. For
other applicators, use the glass plate with the glass surface up (see chapter 7
“Turning the glass plate” on page 23).
Depending on the coating material used, the test may only be carried out in
a ventilated environment.
Heating of substances can lead to risk of explosion, implosion or the release
of toxic or flammable gases. If heating of a product can lead to the release of
hazardous substances, it is necessary to use an appropriate extraction
system.
During operation, the distance to walls and to other objects must be at least
10 cm.
To Next Page
Loading...
