Page 16
5.1 Disassembly
To prevent transport damage, the weight (7) and the glass plate / heating plate
have to be removed:
• Loosen and remove the knurled screw (11) to
remove the weight (7). First turn the weight
upwards by 90 ° and – in reversed order as at the
assembly - first take one side of the weight then
the other out of the guides.
• Remove the glass plate / heating plate.
• Slide the clamping device (5), the drawing unit (19)
and both stops (1 & 2) to the middle of the device.
• Only transport the device in its original packaging.
Disassembled device before and after transport:
5.2 Switching on and off
• Make sure that the apparatus is connected to a power socket with the supplied
power cable (17).
• Turn the FWD-STOP-REV button (13) to the STOP position.
• Switch on the main switch (16) at the back of the apparatus. The operation
light (15) glows green, the device is ready to use.
• Switch off the device after the last application at the main switch (16). The
operation light (15) extinguishes, the device is off.
6 Application
6.1 Preparation
Before the apparatus is prepared for application, you should have decided:
To Next Page
Loading...
