Procom ML200HBA - User Manual

OWNER
’
S OPERATION AND INSTALLATION MANUAL
WARNING: Improper installation,
adjustment, alteration, service or mainte-
nance can cause injury or property damage.
Refer to this manual for correct installation and
operational procedures. For assistance or
additional information consult a qualified
installer, service agency, or gas supplier.
This appliance may be installed in an aftermar-
ket* permanently located, manufactured
(mobile) home, where not prohibited by local
codes.
This appliance is only for use with the type of
gas indicated on the rating plate. This
appliance is not convertible for use with other
gases.
*Aftermarket: Completion of sale, not for purpose of
resale, from the manufacturer.
Do not store, or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
 Do not try to light any appliance.
 Do not touch any electrical switch; do not
use any phone in your building.
 Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
 If you cannot reach your gas supplier, call
the fire department.
Installation and service must be performed by a
qualified installer, service agency or gas
supplier.
ML200TBA
ML300TBA
ML200HBA
ML300HBA
Table of Contents
Important Safety Information.................................2
Product Features.....................................................3
Proper Ventilation & Fresh Air...............................4
Installation................................................................6
Operating Your Heater...........................................10
Cleaning & Maintenance.......................................13
Trouble Shooting...................................................14
Specifications..........................................................17
Parts List.................................................................19
BLUE FLAME VENT-FREE
PROPANE/LP GAS
SPACE HEATER
WARNING: This is an unvented gas-fired
heater. It uses air (oxygen) from the room
in which it is installed. Provisions for
adequate combustion and ventilation air must
be provided. Refer to Air For Combus-
tion and Ventilation section on page 4 of this
manual.
WARNING: If the information in this
manual is not followed exactly, a fire or
explosion may result causing property
damage, personal injury, or loss of life.
WATER VAPOR: A BY-PRODUCT OF UNVENTED
ROOM HEATERS
Water vapor is a by-product of gas combustion. An
unvented room heater produces approximately one
(1) ounce (30ml) of water for every 1,000 BTU’s
(3KW’s) of gas input per hour. Refer to page 3.
Installer: Please leave these instructions with the
consumer.
Consumer: Please retain these instructions for
future use.
Continental Appliance Inc.
5 Musick, Irvine
California, 92618
TOLL-FREE PHONE NUMBER: (877)886-5989

Summary

PROCOM Vent-Free Heater Operation and Installation Manual

Essential Safety and Gas Leak Response

Key safety steps for gas leaks and general precautions.

Critical Safety Information for Heater Use

Heater Safety Precautions and Warnings

Essential safety warnings, operational precautions, and installation guidelines.

Carbon Monoxide and Gas Leak Dangers

Details on carbon monoxide dangers and propane/LP gas properties and leak detection.

Ensuring Adequate Ventilation for Heater Installation

Ventilation Requirements and Classifications

Determining Required Fresh Air Flow

Worksheet to determine space volume and required fresh air flow for heater placement.

Ventilation Airflow Calculation and Methods

Calculating Heater Ventilation Needs

Step-by-step calculation to determine if additional ventilation is needed based on appliance usage.

Providing Ventilation from Adjoining Rooms

Heater Installation: Ventilation and General Guidelines

General Installation and Gas Type Verification

Heater Wall Mounting Bracket Installation

Attaching Mounting Bracket Securely

Heater Mounting and Securing Procedures

Wall Anchor and Stud Attachment Methods

Placing Heater and Installing Securing Screws

Connecting the Heater to Gas Supply

External Regulator and Gas Pressure Setup

Instructions for installing an external regulator and achieving correct gas pressure.

Gas Connection Piping and Components

Details on gas piping, sealant, sediment traps, and test gauge connections.

Gas Connection Testing and Operation Preparation

Procedures for Testing Gas Connections for Leaks

Procedures for testing all gas piping and connections for leaks using soap solution.

Pre-Operation Safety Checks and Gas Smelling

Operating Thermostat Controlled Heater Models

Lighting the Pilot on Thermostat Models

Step-by-step guide for lighting the pilot light on thermostat-controlled models.

Thermostat Control and Temperature Adjustment

Operating Non-Thermostat Heater Models

Lighting the Pilot on Non-Thermostat Models

Step-by-step guide for lighting the pilot light on non-thermostat models.

Heater Inspection, Cleaning, and Maintenance

Inspecting Pilot and Burner Flame Patterns

Cleaning ODS;Pilot and Air Passages

Troubleshooting Ignition and Pilot Issues

No Spark or Pilot Ignition Failure

Addresses issues with ignitor spark and pilot ignition failure.

Pilot Flame Goes Out After Release

Explains why the pilot flame might go out after the control knob is released.

Troubleshooting Burner and Operational Issues

Burner Ignition, Flame, and Backfiring Problems

Troubleshooting Odor, Shutoff, and Air Issues

Heater Odors, Gas Leaks, and Fuel Supply

Heater Shutoff Causes and Gas Odor Diagnosis

Procom ML200HBA Specifications

General

Brand	Procom
Model	ML200HBA
Category	Gas Heater
Language	English