How to stop unwanted odors from my Procom Heater?
To address unwanted odors from your Procom Heater, ventilate the room and stop using odor-causing products while the heater is running. Locate and correct any gas leaks. If you have a propane/LP model, refill the supply tank.
What to do if the Procom Heater pilot light goes out when I release the knob?
If the ODS/pilot lights but the flame goes out when you release the control knob on your Procom Heater, ensure the control knob is fully pressed in. After the pilot lights, hold the knob for 30 seconds. Also, fully open the equipment shutoff valve and hand-tighten gas connections until snug, then tighten a quarter turn more. If these steps don't work, low gas pressure or a dirty pilot may be the cause. Contact your local gas company or clean the ODS/pilot, or replace the ODS/pilot assembly. If the issue persists, the thermocouple or control valve might need replacement.
Why won't the burner light on my Procom Heater after the pilot is lit?
If your Procom Heater burner(s) does not light after the ODS/pilot is lit, try cleaning the burner orifice or replacing it. If that doesn't solve the issue, contact your local gas supplier for assistance.
Why does my Procom Heater smell like gas even when it's off?
If you notice a gas odor from your Procom Heater even when the control knob is in the OFF position, immediately locate and correct any gas leaks. If the odor persists, the control valve may need to be replaced.
Why does my Procom Heater keep shutting off?
If your Procom Heater shuts off while in use, and the ODS (Oxygen Depletion Sensor) is operating, try opening a window or door to increase ventilation. If the problem continues, contact your local gas supplier or clean the ODS/pilot.
How to fix a Procom Heater when the ignitor button produces no spark?
If the ignitor button on your Procom Heater is pressed and there is no spark at the ODS/pilot, you can try replacing the pilot assembly, ignitor cable, or piezo ignitor. Also, ensure the ignitor cable is not pinched and is kept dry.
What to do if Procom Heater sparks but doesn't ignite?
If you press the ignitor button on your Procom Heater and there's a spark at the ODS/pilot but no ignition, first, ensure the gas supply is on and the equipment shutoff valve is open. Fully press in the control knob while pressing the ignitor button and continue holding it down to remove air from the line. Clean the ODS/pilot or replace the ODS/pilot assembly. Check the inlet gas pressure or replace the inlet gas regulator. Finally, ensure the control knob is in the PILOT position.
Why is my Procom Heater burner backfiring?
If the burner is backfiring during combustion in your Procom Heater, clean the burner orifice or replace it. If the problem persists, consider replacing the burner or gas regulator.
Why does my Procom Heater have a high yellow flame?
If your Procom Heater has a high yellow flame during burner combustion, check the burner for dirt and debris and clean it. If the issue continues, replace the gas regulator or contact your local gas supplier.
Why do I smell gas when my Procom Heater is on?
If you notice a gas odor during combustion with your Procom Heater, disassemble the gas tubing and remove any foreign matter. Then, locate and fix any gas leaks.
General| Brand | Procom |
|---|---|
| Model | MN060HBA |
| Category | Gas Heater |
| Language | English |
To Next Page
