Prodigit 3330F User Manual

48 PRODIGIT
CRRES
Command Syntax:
[ PRESet：] CRRES{SP}{ NR2}{；NL}
[ PRESet：] CRRES？ {；NL}
Purpose: Set and read the resistance.
Description: This command is used for setting of load resistance.
1. The least significant number is the 5
th
digit after the decimal point.
2. Should a value be entered that is higher than what is possible then
The 3302F will automatically set its maximum value according the load
module fitted.
3. The engineering unit is Ω.
CV
：
{HIGHLOW}
Command Syntax:
[ PRESet：] CV：{ HIGHLOW}{SP}{ NR2}{；NL}
[ PRESet：] CV：{ HIGHLOW}？ {；NL}
Purpose: Set and Read the value of AC Load Voltage
Description: This command is used for setting the HIGH and LOW levels of
Load voltage. It allows the user to switch between 2 voltage levels.
1. The least significant number is the 5
th
digit after the decimal point.
2. The LOW level resistance value cannot be below the HIGH level.
3. Should a value be entered that is higher than what is possible then
The 3302F will automatically set its maximum value according the load
Module fitted.
4. The engineering unit is V.
CV
Command Syntax:
[ PRESet：] CV{SP}{ NR2}{；NL}
[ PRESet：] CV？{；NL}
Purpose: Set and Read the value of DC Load Voltage
Description: This command is used for setting the of load voltage.
1. The least significant number is the 5
th
digit after the decimal point.
2. Should a value be entered that is higher than what is possible then
The 3302F will automatically set its maximum value according the load
Module fitted.
3. The engineering unit is V.
OCP: START
Command Syntax:
[PRESet：] OCP:START {SP}{NR2}{；NL}
[PRESet：] OCP:START ？ {；NL}
Purpose: Set and read the initial value of OCP test
Description: This command is used for setting the required initial value (I-START) of
OCP test.

Prodigit 3330F Specifications

General

Brand	Prodigit
Model	3330F
Category	Industrial Electrical
Language	English