10. LINE OUT (JACK)
This female JACK connector provides an unbalanced line-level signal with the mix of all the inputs.
Connect it to the input of another audio system or powered speaker.
11. USB PORT
This USB port can be used to supply or recharge the user tablet/smartphone, or for service operation.
12. BATTERY LEVEL
This LED bar shows the battery level when the sound system is switched on.
LOW: this RED LED indicates that the residual power of the internal battery is lower than 50% of the
capacity (the other LEDs are off). When this LED is on, connect your system to a mains line.
50%: this GREEN LED indicates that the residual battery power is between 50% and 75% of the capacity.
75%: this GREEN LED indicates that the residual battery power is between 75% and 100% of the capacity.
100%: this GREEN LED indicates that the internal battery is fully charged.
13. POWER switch
Use this switch to power ON or OFF the loudspeaker. It is "ON" when the switch is in the "I" position.
Note: if the unit is connected to the mains line, the internal supply circuit charges the battery also if the
unit is switched off. In order to extend the battery life, the charging starts when the battery level is below
75% of the capacity, whether the system is on or off.
14. CHARGE LED
GREEN: indicates the equipment is connected to the AC power and the battery is fully charged.
RED: indicates the equipment is connected to the AC power and the battery is charging.
15. AC~ SOCKET
Here’s where you plug in your mains supply cord. You should always use the mains cord supplied with
the device.
To Next Page
Loading...
