Why do my PROEL NET10A Speakers have distorted sound?
If your PROEL Speakers produce distorted sound, it might be because the input signal level is too high. Try turning down your level controls to resolve this issue.
What to do if my PROEL NET10A have no sound?
If your PROEL Speakers have no sound, ensure the input LEVEL control for the channel is turned up. Also, check if the SIGNAL LED is illuminated; if not, your signal level might be too low. Inspect the signal cable, mixer, and other equipment settings and cabling. Verify your signal cables work properly by using a cable tester or replacing them.
How to troubleshoot PROEL NET10A Speakers when there is no power?
If your PROEL Speakers have no power, ensure the mains AC outlet is live by checking with a tester or a lamp. Also, make sure the mains plug is securely plugged into the mains AC outlet and that the loudspeaker's "POWER" switch is on.
How to fix noise or hum coming from my PROEL NET10A?
To address noise or hum in your PROEL Speakers, try the following: * Enable the GND LIFT button on the rear panel. If the problem persists, press all GND LIFT buttons for all system's amplifiers. * Use balanced cables whenever possible. Unbalanced lines may cause noise over long cable runs. * Plug all audio equipment into the same AC circuit to share a common ground.
What to do if PROEL NET10A have different channel levels?
If you notice a different channel level in your PROEL Speakers, check if you are using a balanced cable for one channel and an unbalanced one for the other, as this can cause level differences. Also, ensure that your loudspeaker system is fully connected and that both loudspeakers have the same impedance.
General| Frequency Response | 50 Hz - 20 kHz |
|---|---|
| Max SPL | 124 dB |
| Input Sensitivity | 0 dBu |
| Signal to Noise Ratio | >100 dB |
| Speaker Type | Active |
| Woofer Size | 10 inch |
| Input Connectors | XLR, Jack |
| Output Connectors | XLR |
| Weight | 12 kg |
| HF Driver | 1 inch compression driver |
To Next Page