Why do my PROEL Speakers have distorted sound?
If the PROEL Speakers are producing distorted sound, it might be due to a high input signal level. Try turning down your level controls to resolve this issue.
What to do if my PROEL Speakers have no sound?
If your PROEL Speakers have no sound, ensure the input LEVEL control for the channel is turned up. Also, check your signal level; it might be too low. Inspect the signal cable, mixer, and other equipment settings and cabling. You can also use a cable tester or replace the cable to ensure it is working.
How to fix noise or hum in PROEL Speakers?
If you are experiencing noise or hum with your PROEL Speakers, try enabling the GND LIFT button on the rear panel. You can also press all GND LIFT buttons for all system's amplifiers. Whenever possible, use balanced cables, as unbalanced lines may result in noise over long cable runs. Sometimes, plugging all audio equipment into the same AC circuit helps, so they share a common ground.
How to troubleshoot no power on PROEL Speakers?
If your PROEL Speakers have no power, ensure the mains AC outlet is live by checking with a tester or a lamp. Also, make sure the mains plug is securely plugged into the mains AC outlet.
What to do if PROEL Speakers have different channel levels?
To address different channel levels in PROEL Speakers, check if you are using a balanced cable for one channel and an unbalanced one for the other. Also, ensure that your loudspeaker system is fully connected and both loudspeakers have the same impedance.
Device compliance with FCC rules and potential interference issues.
Explains symbols for dangerous voltage, maintenance instructions, and general cautions.
States PROEL's responsibility for content accuracy, product modifications, and usage.
Graphs showing the frequency response for V10A, V12A, and V15A models.
Adjustable speaker pole with terminal pieces Ø 35 mm and safety pin.
Professional aluminium floor-stand with screw locking system and air-damped release.
C-shape metal bracket for wall mount with +/- 45° rotation.
Adjustable metal bracket for wall mount, horizontal/vertical aiming.
Aluminium coupler for 50mm truss with M12 bolt, used with KPTV.
Heavy duty cover for carrying the speakers.
Important instructions for safe operation, placement, and handling of the product.
Introduction to the PROEL V Series loudspeakers and their features.
Details on XLR/Jack input wiring for balanced/unbalanced signals and XLR link output.
Explanation of MIC/LINE, GND LIFT, LEVEL, and LOW controls for audio adjustment.
Details on HIGH control, SIGNAL/LIMIT, ON indicators, POWER switch, and LINE VOLTAGE selector.
Information regarding the fuse holder, fuse replacement, and the AC power socket.
To Next Page
General