Need help?Do you have a question about the PROEL NEOS SERIES and is the answer not in the manual?
Covers essential safety measures like avoiding opening the unit, exposure to elements, and proper placement.
Notes on professional servicing and disclaimers regarding design changes and specification accuracy.
Details the NEOS series, including transducers, amplifiers, crossovers, and cabinet construction.
Information on packaging integrity tests and handling of goods during transport.
Outlines the warranty period and procedures for reporting defects and returning products.
Instructions for professional installation, emphasizing safety standards and adequate support.
Defines usage restrictions, input signal limits, and explains key safety symbols.
Proel disclaims responsibility for damages from improper use, tampering, or non-compliance with safety rules.
Explains the INPUT, LINK connectors, label, and FULL RANGE/BI-AMP mode selection on passive models.
Details Speakon connector pin assignments for various connection modes like FULL RANGE, BI-AMP, and SUB.
Lists recommended Proel cable codes and specifications for audio connections.
Illustrates stereo linking and subwoofer with satellite connection setups for passive models.
Table detailing amplifier models and output configurations for various passive NEOS speakers.
Provides notes on special cable requirements for certain configurations, like 4-pole cables.
Describes the PowerCon connectors for AC mains input (MAINS ~ / IN) and power output (POWER OUT).
Explains the function of the GND LIFT switch to disconnect the amplifier's audio circuit earth connection.
Details the VOLUME control and indicators like SIGNAL/CLIP, ON, and PROT/TEMP for amplifier status.
Covers switches for HI-PASS 80HZ, PHASE inversion, crossover frequency (160Hz/100Hz), and FILTER/FLAT output.
Information on the technical data label and the location and replacement of power fuses.
Describes XLR and JACK connectors for balanced and unbalanced audio signal inputs.
Details PowerCon AC connectors (Type A for input, Type B for output) for power supply.
Diagram illustrating how to link NEOS active speakers in a stereo configuration.
Diagram showing the connection of multiple subwoofers in an array.
Diagram illustrating how to connect satellite speakers with subwoofers, including filtered outputs.
Technical specifications for NEOS10P, NEOS12P, and NEOS15P passive loudspeaker models.
Technical specifications for NEOS10A, NEOS12A, and NEOS15A active loudspeaker models.
Technical specifications for NEOS122P, NEOS152P, and NEOS115SP passive loudspeaker models.
Technical specifications for NEOS122A, NEOS152A, and NEOS115SA active loudspeaker models.
Technical specifications for NEOS215SP and NEOS218SP passive loudspeaker models.
Technical specifications for NEOS215SA and NEOS218SA active loudspeaker models.
Details the dual-angle speaker flange and its adjustment for optimal audience coverage.
Explains how to rotate the horn on full-range models for asymmetrical dispersion in horizontal use.
References graphical data for frequency response and directivity index of NEOS speakers.
References graphical data for polar coverage maps showing attenuation at different angles.
Describes the KP210 adjustable metal pole and SPSK300BK adjustable speaker stand.
To Next Page
General