Proflex TRX1 - Treadmill Operation: Folding, Unfolding, and Moving; Safety Tether and Emergency Stop; Getting Started with Treadmill Operation

6. Rotate the console (8) to the desired position, then secure it using the console screw ( 9). Tighten the screw (rotate right) using the supplied Allen
Once assembled, the machine ready for use
Folding
1. Remove the locking screw (3). The screw can be stored in the bracket next to where it
2. Hold the handle assembly and gently lift the end of the belt platform ( 1) up toward the handle frame ( 2).
Pull the spring loaded locking pin ( 4) out so the belt platform is fully in the folded position, then release the pin so that it enters the hole in the belt platform.
Unfolding
1. With the treadmill upright, hold the belt platform ( 1) steady then pull the spring loaded locking pin ( 4) out from the handle frame ( 2).
2. Gently lower the belt platform down so it rests on the floor.
3. Secure the belt platform to the handle assembly using the locking screw ( 3) and firmly tighten by hand (rotate right), against the handle mounting frame.
Note: Always set-up the equipment on a flat and level surface. If the equipment “rocks”, (if applicable) rotate
feet under front of machine to move up or down as needed so equipment is steady
Moving
The unit can be tilted onto its wheels for easy moving and storage. With the treadmill in the folded and locked position, firmly grasp the handlebar with both
hands. Next, carefully tilt the treadmill back until it rolls freely on the transport wheels.
Caution: Do not attempt to move the treadmill while it is in the unfolded position. • Be careful when moving the treadmill to avoid scratching floor surfaces
Operating the Treadmill
Safety Tether and Emergency Stop
The treadmill comes equipped with a “safety tether”. The safety tether must be attached to the console in order for the treadmill to run. It is designed to attach
to your clothing so that if you leave or fall from the treadmill it will stop automatically, helping prevent injury.
Before beginning a workout session ensure that the safety tether is properly placed onto the console and that the clip is securely attached to your clothing.