16
press the desired direct memory button under which the num-
ber must be saved, the number will be stored directly
Correcting:
It’s not possible to correct a direct memory. To adjust, you’ll just need to program the
new number over the old number; the old number will be overwritten.
Deleting:
It’s not possible to delete a direct memory. However, you can program a non-existing
number (e.g. only a 0) over the old number; the old number will be overwritten.
5.3 2-buttons memories:
Programming:
use the keypad to enter the phone number
use the C button to delecte any incorrect input
use the P button to insert a dialling pause
press the OK button
press the M.. button
press one of the 10 dial buttons or the * or # button on the
keypad, the number will be saved directly
Correcting:
It’s not possible to correct a 2-buttons memory. To adjust, you’ll just need to program the
new number over the old number; the old number will be overwritten.
Deleting:
It’s not possible to delete a 2-buttons memory. However, you can program a non-existing
number (e.g. only a 0) over the old number; the old number will be overwritten.
To Next Page
Loading...
