Note: If there is a thin sheet of clear plastic on the
face of the console, remove it.
BATTERY INSTALLATION
UNPLUG THE POWER CORD. The console re-
quires three "AA" 1.5 V batteries (included). Alkaline
batteries are recommended. Open the battery cover as
shown in the drawing at the upper right. Insert three
batteries into the console, making sure that the nega-
tive (–) ends of the batteries are touching the springs in
the console.
Close the battery cover, push up on the battery cover
tab, and then push the tab forward as shown in the
inset drawing. Make sure that the tab locks into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in (see page 7).
Stand on the foot rails of the
treadmill. Find the clip at-
tached to the key and slide
the clip onto the waistband
of your clothes. Next, insert
the key into the console.
Test the clip by carefully
taking a few steps backward until the key is pulled
from the console. If the key is not pulled from the
console, adjust the position of the clip.
CAUTION:Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing at
the lower right) whilst using the treadmill.
When the key is removed from the console,
the walking belt will stop.
• Adjust the speed in small increments.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.
Battery
Cover
Tab
Batteries
8
Incline
Control
Decal
Speed
Control
Pulse Sensor
Clip
To Next Page
Loading...
Need help?
General