Why does my ProForm Treadmill power turn off during use?
If your ProForm Treadmill turns off during use, check the circuit breaker located on the treadmill frame near the power cord. If tripped, wait five minutes, then press the switch back in. Also, ensure the power cord is securely plugged in; if so, unplug it, wait five minutes, and plug it back in. Finally, remove and reinsert the key from the console.
What to do if my ProForm Treadmill power does not turn on?
First, ensure the power cord is plugged into a surge suppressor and that the surge suppressor is plugged into a properly grounded outlet. Use a single-outlet surge suppressor meeting the specifications. Note that the treadmill isn't compatible with GFCI-equipped outlets. Next, check that the key is inserted into the console. Finally, check the reset/off circuit breaker located on the treadmill frame near the power cord. If the switch protrudes, the circuit breaker has tripped. To reset it, wait five minutes, then press the switch back in.
How to fix a ProForm 831.24624.0 walking belt that slows down when I walk on it?
If the walking belt is overtightened, remove the key and unplug the power cord. Use the hex key to turn both rear roller bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 inches off the walking platform. Keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes.
Why is my ProForm 831.24624.0 walking belt off-center or slipping?
If the walking belt has shifted to the left, use the hex key to turn the left rear roller bolt clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the left bolt counterclockwise 1/2 of a turn. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Also, using the hex key, turn both rear roller bolts clockwise, 1/4 of a turn. When correctly tightened, you should be able to lift each edge of the walking belt 2 to 3 inches off the walking platform. Keep the walking belt centered. Then, plug in the power cord, insert the key, and carefully walk on the treadmill for a few minutes.
To Next Page
General