8
6. Hold the treadmill firmly with both hands, and raise the
treadmill to the storage position as described on page
15. If the latch pin does not align with the hole in the
Catch (not shown), it will be necessary to remove the
Latch Spacer (56). Remove the two Screws (101), the
Latch Assembly (9), and the Latch Spacer. Reattach the
Latch Assembly with the two Screws. Make sure that the
latch pin engages the Catch.
56
9
101
Latch Pin
6
7. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 18). To protect the
floor or carpet from damage, place a mat under the treadmill.
To Next Page
Loading...
Need help?
General