ASSEMBLY AND OPERATION
TheCROSS WALK isdeliveredin the compactstowaway position. Set
theCROSSWALK in a cleared area and removeall packihg materials.
Make surethatall partsare includedbefore disposingof Ihe packing
materials.Slidethe LockKnobWasher (78) onto the I.o_kKnob(77).
Raisethe Upright(10) to the verticalpositionand lightenIhe LockKnob
intothe Upright.The useof the remaining parts will be describedin
othersectionsof this manual.
_ 10
APPLYINGSIUCONE LUBRICANT
To reducethe Frictionof thewalking belt and minimizewear, a non-oil-,
non-petroleum-basesiliconelubricantmustbeapplied tothe walking
platform beforethe CROSSWALK is used. WITH THEPOWER CORD
UNPLUGGED,lifteach sideof thewalking belt and spray lubricantgen-
erouslyonlo the indicatedarea. Reapplylubricantafter everytenhours
of use,or wheneverperformance decreases.Lubricantisavailable at
hardware and automotivestores.Uni*SportTM sprayisrecommended.
PLUGGING IN THEPOWER CORD
Thisproductmustbe grounded. If itshouldmalfunctionor break down, grounding providesa path of leastresistance
for electriccurrentto reducethe riskof electricshock.Thisproductisequipped with a cord having an equipment-
groundingconductorand a groundingplug. PlugIfle power cord intoan appropriate outlet Iflat is properly installed
and grounded in accordancew;th all local codesand ordinances.
A DANGER:Improperconnectionof the equlpment-grounding conductor can resultin a riskof electricshock.
Check with a qualified electricianor serviceman ifyou are in doubt as to whether the product isproperlygrounded. Do
notmodify theplug provided with the product--if itwill not fittheoutlet, havea proper outletinstalledby a qualified
electrician.
This product is for useon a nominal 120-volt circuit, and has a grounding plug as shown in Drawing 1. A temporary
adapter like the adapter shown in Drawing 2 may be usedtoconnectthis plug toa 2-pale receptacleas shownin
Drawing 2 iFa properly grounded outlet isnot available.The temporary adapter shouldbe usedonly untila properly
grounded outlet(Drawing 1) can be installed by a qualified electrician.The green-coloredear, lug, or the like extend-
ing fromtheadapter mustbe connected toa permanent ground suchas a properly grounded outletbox cover. When-
ever the adapter isused,it mustbe held in place by a metal screw. Some 2-pole receptacleoutletbox coversare not
grounded. Contacta qualified eledrician to determine if Ifle outletbox cover isgrounded before usingan adapter.
1
GroundedOutletBox
GroundingPlug
Grounding Pin
Grounded Outlet
Matal Screw
Grounded Outlet Box
Grounding Pin
Grounding Plug
S
To Next Page
Loading...
Need help?
General