OPERATING INSTRUCTIONS
WARNING: the heater must be properly installed before it is used.
SETTING THE THERMOSTAT
1) Rotate thermostat knob clockwise to high position, POWER INDICATOR will turn yellow.
2) After room reaches desired comfort level rotate thermostat knob counter clockwise until the
thermostat to OFF position.
NOTE: Heater will cycle on and off to maintain room temperature.
SELECTION SWITCH
Using the SELECTION SWITCH, you can control the heating
output: I for 6250W, II for 7500W.
THERMAL CUT-OUT
The heater will automatically shut off when parts of it overheat. The heater will turn ON again when
the abnormal temperature returns to normal levels. Should the unit overheat and cause the thermal
cut-out to cycle, the cause of the overheating should be determined and corrective action taken
before further operation.
NOTE: When the thermal cut-out is activated, the caution indicator will turn red. In this case,
immediately turn the heater OFF and inspect for any objects on or adjacent to the heater that may
To Next Page
Loading...
