Progressive TD65-2 - Specifications

6
MACHINE SPECIFICATIONS
DESCRIPTION
TD65-2 (12’)
TD65 (15.5’)
Recommended HP
25-40
30-50
Cutting Width
12 ft.
15 ½ ft.
Transport Width
7 ½ ft.
8 ½ ft.
Height
5 ½ ft.
7 ½ ft.
Length
14 ft.
14 ft.
Ground Clearance
9 ¼”
9 ¼”
Spindles
7
9
Blades
3 per Centre Deck
2 per Wing Deck
3 per Deck
Weight
2380 lbs.
2720 lbs.
Tongue Weight Transport
445 lbs.
580 lbs.
Mowing
235 lbs.
330 lbs.
Mowing Capacity MPH 2
4
6
2.9 acres/hr
5.8 acres /hr
8.7 acres/hr
Assumes no stops or overlaps
3.75 acres/hr
7.5 acres/hr
11.3 acres/hr
360 Degree Turn
24” uncut circle
0” uncut circle
Ground Pressure
7 PSI
8 PSI
Tire to Ground
310 square inches of contact
Castors
15 X 6. NHS – 4 ply pneumatic tires.
Number of Tires
10 on decks, 2 on main frame
Transport Tires
18 X 9.5 NHS – 6 ply turf saver tires.
Deck Drive
PTO shaft to right angle gear
box driving 2-“B” section belts
to 3 heavy-duty spindles.
Hydraulics
Requires 1 double acting outlet, all
hoses supplied to tractor.
Belt Adjustment
Easily made by loosening four
bolts at gearbox base and
adjusting the slide plate
forward or backward for
retightening.
Deck
Construction
3/16” steel plate formed and welded
with supporting members at high
stress areas to achieve maximum
strength. Deck is 5” deep.
Cutting Height
Easy to use spacer bushings
allow adjustment from 1” to 5”
in 3/8” increments.
Hitch
4 position, with height settings from
10 ½” to 15”. Safety chain with hook
according to Dept. of Transport
regulations.
Spindles
1 3/16” dia. (30 mm) spindle is
carried in 2 re-greaseable ball
bearings, which are housed, in
a precision machined hub.
PTO Shafts
Telescoping agricultural PTO shafts,
with proper safety shields. 1 3/8” – 6
spline quick-disconnect yokes on
both ends with Ring Lock collars.
INPUT PTO – Category # 4
DECK PTO – Category # 2
Blades
High lift, heat treated, alloy
steel - 5/16” x 2 ½” x 23”.
Optional: Low lift blades
Speeds
Tractor PTO – 540 RPM
Blades – 3040 RPM
Blade Tip Speed – 18,287 FPM
Anti-Scalp
Rollers
Standard on front of wing
decks.
Paint Finish
Electrostatically painted with oven
baked finish.
Main Gearbox
4 shaft gearbox with 1 3/8 - 6
spline shafts
SMV Sign
Located at back of mower for safety.
REAR DEFLECTOR AND MULCHING KITS AVAILABLE UPON REQUEST.
Design and specifications are subject to change without notice.