PROLEC PME 500 - Page 6

Table of contents (continued)
8.3.2 Min Radius Limit Setting - Known Radius
37
8.3.3 Min Radius Limit Setting - Using Current nearest Point
38
8.3.4 Machine Envelope Controller (MEC) - Min Radius
39
8.4 Low Limit
8.4.1 Low Limits Menu
40
8.4.2 Low Limit Setting - Known Radius
41
8.4.3 Low Limit Setting - Using Current Lowest Point
42
8.4.4 Machine Envelope Controller (MEC) - Low
43
8.5 Slew Limits Menu
44
8.5.1 Angular Slew Restriction - Using current Slew Angle
45
8.5.2 Virtual Wall Restriction - using virtual wall
47
8.5.3 Twin Virtual Wall Restriction - using twin virtual wall
49
8.5.4 Multipoint Wall Restriction - using Multipoint Wall
51
8.5.5 Machine Envelope Controller (MEC) - Slew / Wall
54
9 System Messages 55
9.1 On Screen Messages
55
9.2 LED and Internal Alarm Warnings
56
10 Daily checks 56
11 Repair 56