Downloaded from www.vandenborre.be
5.1 Plug into a power outlet.
5.2 Push the switch ① to position “I”, the lamp will illuminate; push to position “0”, the
lamp will turn off.
5.3 Push the switch ② to position “1、2、3”, the motor will start “low、mid、high” (three
speeds) push to position “0”, the motor will turn off.
Air ducting setting
Outdoor Air ducting: Turn the adjuster to outdoor (see pic 3A), install the outlet; open the
cooker hood, the smoke will be vented to the outside.
Indoor Air ducting: Turn the adjuster to indoor (see pic 3C), install the outlet cover, open the
cooker hood, the smoke will be vented inside.
NOTE:
The filter is flame retardant.
USE AND MAINTENANCE
It is recommended to operate the appliance just before to cooking.
There shall be adequate ventilation of the room when the cooker hood is used at the same time as
appliances burning gas or other fuels (not applicable to appliances that only discharge the air back
into the room.)
It is recommended to leave the appliance in operation for 15 minutes after cooking is finished in
order to completely remove cooking vapors and odors’.
Don’t place a large flame under the cooker hood.
Regulations concerning the discharge of air have to be fulfilled.
CLEANING
In order to prevent a fire hazard, it is recommended to clean the filter after a maximum of 2
months by carrying out the following instructions.
Disconnect from the mains before cleaning, then remove the filters from the cooker hood and
wash them in a solution of water and mild liquid detergent, leave to soak.
Rinse thoroughly with warm water and dry thoroughly.
The filters also can be washed in the dishwasher.
The aluminum panels may alter in color after several washes. This is not cause for customer
To Next Page
Loading...
