To Next Page
J
Joseph HunterSep 9, 2025
What does it mean when Proline I3000 UPS signals 'Battery Low'?
- CChristopher MelendezSep 9, 2025
If your Proline UPS signals 'Battery Low' and you hear an audible alarm every second, it means the battery is almost empty.
What does it mean when Proline I3000 UPS signals 'Battery Low'?
If your Proline UPS signals 'Battery Low' and you hear an audible alarm every second, it means the battery is almost empty.
What to do if Proline I3000 shows ambient temperature high?
If your Proline UPS displays 'Ambient temperature high', it indicates that the ambient temperature is too high. Check the environment ventilation.
How to resolve 'Site Fail' error on Proline I3000?
If your Proline UPS shows a 'Site Fail' error, it means the phase and neutral conductors at the input of the UPS system are reversed. Rotate the mains power socket by 180° or correctly connect the UPS system.
What does 'Inverter Short' mean on Proline I3000?
If the Proline UPS displays 'Inverter Short', it means there is an output short circuit. Remove all loads, turn off the UPS, and check the output of the UPS and loads for any short circuits. Ensure the short circuit is removed and the UPS has no internal faults before turning it on again.
What to do if Proline I3000 UPS shows EPO active?
If your Proline UPS shows 'EPO active', it means the EPO (Emergency Power Off) function is enabled. Plug into the EPO switch.
Guidelines for installing the UPS unit safely and preventing hazards.
Instructions for safe operation of the UPS system, avoiding hazards.
Guidance on maintenance, servicing, and handling faults safely.
Details on connecting the UPS input and output power.
Procedure for fully charging the UPS batteries.
Steps for turning on the UPS system with utility power.
Instructions for safely turning off the UPS in different modes.
Lists operating modes, warnings, and faults with their corresponding codes.
Details common UPS problems, their possible causes, and recommended remedies.
Guidelines for installing the UPS unit safely and preventing hazards.
Instructions for safe operation of the UPS system, avoiding hazards.
Guidance on maintenance, servicing, and handling faults safely.
Details on connecting the UPS input and output power.
Procedure for fully charging the UPS batteries.
Steps for turning on the UPS system with utility power.
Instructions for safely turning off the UPS in different modes.
Lists operating modes, warnings, and faults with their corresponding codes.
Details common UPS problems, their possible causes, and recommended remedies.
General| Wattage | 2400W |
|---|---|
| Output Frequency | 50/60 Hz ± 1 Hz |
| Waveform | Pure Sine Wave |
| Typical Recharge Time | 4-6 hours to 90% capacity |
| Protection | Overload, discharge, and overcharge protection |
| Communication | USB, RS232 |
| Operating Temperature | 0°C to 40°C |
| Capacity | 3000VA |
| Input Voltage | 230VAC |
| Input Frequency | 50/60Hz |
| Output Voltage | 230VAC |
| Battery Type | Sealed Lead-Acid (SLA) |
| Outlets | IEC Outlets |
| Storage Temperature | -15°C to 45°C |
| Humidity | 5% to 95% (Non-condensing) |