37
How to stop a programmed recording
• Press and hold the (stop) button for at least five seconds, until the recording stops and
‘TMR’ goes off the display.
• Press the (power) button to put the video recorder back on stand-by ready for any
more programmed recordings. ‘TMR’ will light up again.
Important notes about VIDEOplus+ and programmed recordings
• If you enter a VIDEOplus+ number, and choose the repeat status of the timer programme,
but the VIDEOplus+ number entry display comes back on, there was probably something
wrong with the PlusCode number you entered. If the video recorder is set with the wrong
time or date, this could have the same effect. It is unlikely they would be wrong, but you
can check (please see ‘Setting or checking the time and date’ on page 20).
• When the video recorder will not let you enter a particular date (or time), you have
probably pressed a wrong number. Possibly you have selected a daily recording ‘Monday
to Friday’ or ‘Monday to Saturday’ and the date you entered was on one of the days the
recording should not take place.
• If you set the video recorder to record every day, the start date of the first recording must
be within one week.
• If you try to set the timer after you have set all eight timer blocks, ‘Important - All timer
programmes have already been programmed’ will appear on the television screen for a
few seconds.
• After you have set a recording and switched the video to stand-by, if ‘TMR’ is flashing in
the front panel, there is something wrong which will stop the recording from taking place.
Check you have loaded a cassette.
• If the video recorder ejects the cassette when you press the or POWER button, the
safety tab on the cassette is broken out. Please read ‘Protecting cassettes from being
recorded over’ on page 21.
• Before a programmed recording can work, you must put the video recorder on stand-by by
pressing the POWER or button.
• You can use the video recorder as normal when it is not making a programmed recording,
but don’t forget to put it on stand-by afterwards. You will get no warning if you are using
the video recorder when the programmed recording is due to start.
• You cannot use the video recorder while a programmed recording is being made. If you
want to stop the programmed recording, please read ‘How to stop a programmed
recording’ above.
• If the video recorder reaches the end of the cassette during a programmed recording, it
will eject the cassette.
• You can check how much recording time is left on a cassette by using the information
display described on page 26.
• If there is not enough ‘SP’ recording time left on a cassette, the video will switch to ‘LP
speed’ to double the recording time.
recordings
Programmed
To Next Page
Loading...
General